The CNC carving machine has been used more and more widely, the accessories in the engraving machine, and all kinds of problems in how we should go back to the factory after, how can let after-sales personnel more clearly to understand where wrong with your machine, why don't your machine running, so, can be more clear let after-sales personnel to solve the problem for you, So let's talk about the reasons and solutions of engraving machine stuck shaft.
To understand the problem we should know what is engraving machine stuck shaft firstly, stuck shaft refers to the equipment in the process of running in a direction suddenly stuck immovable tombstone engraving machine can not operate normally. In general, the screw drive equipment is prone to this problem. The machine suddenly stops in a certain direction in the process of engraving, but the motor is still buzzing, which will lead to the dislocation of the machine carving. If this problem often occurs, we have to pay close attention to timely repair.
So what causes the problem of engraving machine stuck shaft? For example, the engraving machine does not work continuously for more than 24 hours. If the engraving machine is in working state for a long time, the electricity will heat up, and the heat will fail to a certain extent. If the motor parameters or pulse equivalent are correct, sometimes when you reinstall the system and then install the software, the parameters inside will be restored to the default value, many parameters need to be modified, and then to see whether your processing speed or manual speed is too fast, you can lower the speed to try. There are sundries on the drive screw/guide rail. It is recommended to clean them in time.
Engraving machine XY axis always card and then dislocation:
Always right dislocation means is X axis misalignment, if is the rack machine, you need to check the fit of the eccentric wheel and rack is loose, if eccentric there is normal, then measure the diagonal, look at the length of the diagonal is the same, is not the same as the diagonal length, you need to pull down the screw of the beam, adjust the beam, if diagonal is normal, It is necessary to remove the screws on the beam and adjust the beam. If the diagonal line is normal, replace it with an X-axis cable. Sometimes, the cable will also cause such dislocation when it receives interference or poor contact.
Engraving machine Y axis slide block stuck how to solve:
First blow off the ash on the edge of the slider with an air gun. If it is a woodworking machine, it should be a square slider, which can be removed. When I say removed, it is not to take out, but to loosen the screw and let the slider move back and forth on the guide rail.
